Mitsubishi Electric Mr.SLIM SLZ-M FA Series Operation Manual page 11

3. Operation
< How to set the fixed up/down air direction >
Note:
• For SLZ-M·FA series, only the particular outlet can be fixed to certain
direction with the procedures below. Once fixed, only the set outlet is
fixed every time air conditioner is turned on. (Other outlets follow UP/
DOWN air direction setting of remote controller.)
■
Explanation of word
• "Refrigerant address No." and "Unit No." are the numbers given to
each air conditioner.
• "Outlet No." is the number given to each outlet of air conditioner.
(Refer to the illustration below.)
• "Up/Down air direction" is the direction (angle) to fix.
Reset 1 2
horizontal
Horizontal airflow
Remote controller setting
The airflow direction of this outlet
is controlled by the airflow direc-
tion setting of remote controller.
Electric Component box
Outlet No.4
Outlet No.3
Note:
The outlet No. is indicated by the number of grooves on both ends of
each air outlet. Set the air direction while checking the information
shown on the remote controller display.
Air outlet identification marks
3 4 5
Downward
Fixed
The airflow direction of this outlet is fixed
in particular direction.
* When it is cold because of direct
airflow, the airflow direction can be
fixed horizontally to avoid direct airflow.
Outlet No.1
Outlet No.2
■
Manual vane angle (Vertical air direction) (Wired remote controller)
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu:
Cursor
F1 F2 F3 F4
Comfort
Manual vane angle
3D i-See sensor
Setting display:
Cursor
F1 F2 F3 F4
Airflow direction setting
Vertical
Horizontal
Setting display:
Cursor
F1 F2 F3 F4
Manual vane angle
Ref. address
Unit No.
Identify unit Check button
Input display:
Cur. Address Check
F1 F2 F3 F4
Manual vane angle
Ref. address
Unit No.
Vane
4-way /2-way
Input display:Angle button
Cur. Cursor Angle
F1 F2 F3 F4
Select "Comfort" from the Operation
menu, and press the [SELECT]
button.
Select "Manual vane angle" with the
[F1] or [F2] button, and press the
[SELECT] button.
Select "Vertical" with the [F1] or [F2]
button, and press the [SELECT]
button.
* This screen appears only when
the horizontal air direction
function is supported.
Move the cursor to "Ref. address"
or "Unit No." with the [F1] button to
select.
Select the refrigerant address and
the unit number for the units to
whose vanes are to be fixed, with
the [F2] or [F3] button, and press
the [SELECT] button.
• Ref. address: Refrigerant address
• Unit No.: 1, 2, 3, 4
Press the [F4] button to confirm the
unit.
Select "Vane" with the [F1] button.
Select "4-way" or "2-way" with the
[F2] or [F3] button, and press the
[F4] button.
9
en