Toro TimeCutter 79682 Manual page 3

ROPS Kit
TimeCutter
Model No. 79682—Serial No. 400000000 and Up
Store this document with the Operator's Manual for the traction unit.
Safety
Rollover Protection System
(ROPS) Safety
•
The ROPS is an integral safety device. Do not
remove any of the ROPS components from the
machine.
•
Ensure that the seat belt is attached and that you
can release it quickly in an emergency.
•
Always wear your seat belt when the roll bar is
installed.
•
Check carefully for overhead objects before you
drive under them, and do not contact them.
•
Keep the roll bar in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace damaged ROPS components. Do not
repair or alter them.
•
Wheels dropping over edges, over steep banks, or
into water can cause a rollover, which may result
in serious injury or death.
•
Do not wear the seat belt when the roll bar is not
installed.
•
In the event of a rollover, take the machine to an
Authorized Service Dealer to inspect the ROPS.
•
Use only Toro approved accessories and
attachments for the ROPS.
© 2024—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Riding Mower
Safety and Instructional
Decals
Register at www.Toro.com.
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
145-6387
1. Warning—Read the Operator's Manual and wear a seat
belt.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3466-871 Rev A
Installation Instructions
decal145-6387
*3466-871*