Parameters - Tandy 102 Owner's Manual

Checking the Settings
3. Check the newly-set
Before communicating with
parameters by pressing
ITID
( ENTER
l.
another computer, you need
to
check TELCOM's communica-
Whal the Settings Uean
ti on parameters (Figure 8. l) and
make sure that they are set Some parameters settings-such
correctly.
as the connector- are extremely
You can check these parameters
important. If set incorrectly, no
transmission will take place.
when you first enter TELCOM
Other settings-such as the dial
and anytime before entering
type-are less important. The
TELCOM's terminal mode by
following describes TELCOM's
pressing
(£[)
( ENTER
l.
parameter settings in order of
To change the parameter settings:
importance.
1. Press
ITID
and you see the
"Stat" prompt.
2. Enter the new parameter set-
tings, for example M7E1E
( ENTER ).
(You do not need to
include the last parameter-the
dial type-unless you want to
change it.)
connector word
length
Connector (M7EIE,10 pps).
Make sure this setting is correct.
Otherwise, no transmission will
take place.
Connector:
M- PHONE (built-in modem)
l - RS-232, 75 baud
2-RS-232 ,
110
baud
M 7 E E 10 pps
parity stop sto p/
bit sta rt
dial
type
Figure 8.1. TELCOM's communicatio n parameters.
86 I Setting Comm unication Parameters
I
I
I
I
I
I
I