Port Configuration - ZyXEL Communications Dimension GS-1548 User Manual

Chapter 6 Port Settings
Table 8 Port Status (continued)
LABEL
Flow Control
PVID

6.2 Port Configuration

Use this screen to configure individual port settings.Click a port number in the
Port Status screen to access this screen.
Figure 30 Port Configuration
The following table describes the labels in this screen.
Table 9 Port Configuration
LABEL
Port
Admin
Auto
Negotiate
Speed
Duplex
50
DESCRIPTION
Enables access to buffering resources for the port thus ensuring lossless
operation across network switches. This field displays either Enabled or
Disabled.
The PVID field specifies what tag the incoming untagged frames receive
on that port so that the frames are forwarded to the VLAN group that the
tag defines.
DESCRIPTION
This is the port index number.
Select Enable to activate the port or Disable to deactivate the port.
Select Enable and the port will negotiate the speed, duplex mode and flow
control settings with the peer port. If the peer port does not support auto-
negotiation or turns off this feature, the Switch determines the connection
speed by detecting the signal on the cable and using half duplex mode.
Select Disable to configure the port settings manually. When the Switch's
auto-negotiation is turned off, a port uses the pre-configured speed and
duplex mode when making a connection, thus requiring you to make sure
that the settings of the peer port are the same in order to connect.
Select the speed and the duplex mode of the Ethernet connection on this
port. Choices are 10Mbps Half, 10Mbps Full, 100Mbps Half, 100Mbps
Full and 1Gbps Full.
GS-1524/GS-1548 User's Guide