Table of Contents
Advertisement
Each numbered IR emitter jack corresponds to a specific source device. When an IR remote control is
used in a particular zone, the system determines which source device is selected for that zone and sends
the IR signal out to that specific device's IR emitter.
In addition to the specific IR signaling to individual source devices, the ALL jack repeats all IR signals
received, regardless of the zone or the selected source device. With the ALL output, you can use a single
IR emitter to process the signals for all devices, so long as they are within range and have a clear line-of-
sight to the IR emitter.
To install an IR emitter, simply insert the 3.5 mm plug for the emitter into the appropriate IR Emitter jack.
Position the emitter bulb so that it is within range and has a clear line of sight to the source device(s). If
the emitter cord is not long enough, you can use any 3.5 mm TS or TRS extension cable to extend its
reach.
CONNECTING POWER
1.
Using the included AC power cable, plug the C13 end into the C14 panel connector on the back of
the Master Controller/Amplifier. Plug the other end into a nearby AC power outlet.
2. Plug in each other device in the system (source devices, external amplifiers, etc.) into nearby AC
power outlets.
3. Power on each device.
FINAL INSTALLATION
Once you have verified the proper operation of all aspects of the system, it is time to take it all apart and
perform the permanent installation.
1.
Turn off and unplug all equipment.
2. Remove all connecting wires and cables and route them to their permanent locations.
3. Reattach all equipment following the steps listed above.
4. For each zone, perform a complete test of full operation as described in the Test Operation
section above.
Congratulations! You have completed the installation and can now enjoy music
or other audio material throughout your home.
14
Advertisement
Table of Contents
