Table of Contents
Advertisement
PRODUCT OVERVIEW
FRONT PANEL
1.
Power Button — press the power button to turn the controller/amplifier on or off. NOTE: When
the controller is powered on, each zone will remain on standby until its keypad is activated.
2. Power Led Indicator — this LED indicator is off when the controller is powered off and will
illuminate red when there is power.
3. Zone Status LED Indicators — these multicolor LEDs illuminate blue whenever the individual
zone keypad is activated. If the amplifier is driven into distortion, the audio signal will cut off and
the LED will change color to red, indicating that you should immediately reduce the volume level
using the zone keypad.
REAR PANEL
4. Preamp Outputs — each of these four stereo pairs of RCA jacks is used to connect to a
dedicated power amplifier, instead of using the built-in amplifier.
5. Bridge Switch — each of these slide switches is used to switch the zone between
Bridged Mono
mode, you can only connect an 8Ω load.
6. Speaker Output — each of these removable Euroblock terminal blocks is used to connect a pair
of speakers in
7. Source Input 1 — this analog stereo RCA pair is used to connect to the line-level output of an
audio device, such as a CD player. When a 12V DC trigger signal is detected on the System PA
input, the audio on this input is broadcast to all zones.
8. Source Input 2 — this analog stereo RCA pair is used to connect to the line-level output of an
audio device, such as a CD player.
9. Source Input 3 — this analog stereo 3.5 mm TRS jack is used to connect to the level output of an
audio device, such as a CD player, or the headphone output of a mobile device.
10. Source Input 4 — this 3.5 mm TRS jack can be used as an analog stereo audio input or as a digital
optical S/PDIF (Mini TOSLINK®) input. Instead of requiring a physical switch to change modes, the
controller will automatically detect the type of signal and adjust itself accordingly.
11. Source Inputs 5 and 6 — each of these RJ45 Ethernet jacks is used to connect to a digital audio
source, such as the 13358 Multizone Source Keypad, using CAT5e or CAT6 cables.
Stereo
. In
mode, you can connect 4Ω or 8Ω speakers. However, in
Stereo
mode or a single speaker in
Bridged Mono
mode.
5
Stereo
and
Bridged Mono
Advertisement
Table of Contents
