Electrolux EOK9S8B0 User Manual page 28

Table of Contents

Advertisement

Problem description
There is dirty water on the bottom
of the cavity after descaling.
There is too much water on the
bottom of the cavity after cleaning.
Cleaning performance is not satis‐
factory.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
Trouble with wireless network sig‐
nal.
New router installed or router con‐
figuration changed.
The wireless network signal is
weak.
The wireless signal is disrupted by
microwave oven placed near the
appliance.
12.2 Error codes
When the software error occurs, the display shows error message. You will find the list of
problems in the table below.
Code and description
C2 - the Food Sensor is in the appliance cavity during
Pyrolytic Cleaning.
C3 - the door is not fully closed during Pyrolytic Clean‐
ing.
F111 - Food Sensor is not correctly inserted into the
socket.
F240, F439 - the touch fields on the display do not
work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect with the
control panel.
F131 - the temperature of the steamer sensor is too
1)
high.
28
ENGLISH
Cause and remedy
The grill -/ roasting pan is on a wrong shelf position.
Remove the remaining water and the descaling agent from the bottom of the
appliance. Next time put the grill -/ roasting pan on the first shelf position.
You put too much detergent in the appliance before you started cleaning.
Next time evenly spread the thin layer of a detergent on the cavity walls.
You started cleaning when the appliance was too hot.
Wait for the appliance to cool down. Repeat cleaning.
You did not remove all the accessories from the appliance before cleaning.
Remove all the accessories and repeat cleaning.
Check if your mobile device is connected to the wireless network. Check
your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer to "Before first use"
chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using microwave oven and the Remote operation of the appliance at
the same time. Microwaves disrupt WiFi signal.
Remedy
Take out the Food Sensor.
Close the door.
Fully plug Food Sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Check your network connection. Refer to "Before first
use" chapter, Wireless connection.
Turn the appliance off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the appliance off and on.
Turn the appliance off and wait until it cools down. Turn
the appliance on again.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eok9s8t0

Table of Contents