Electrolux EOK9S8B0 User Manual page 10

5.3 Wireless connection
To connect the appliance you need:
• Wireless network with the Internet
connection.
• Mobile device connected to the same
wireless network.
1. To download My Electrolux Kitchen app:
Scan the QR code located on the rating
plate with the camera on your mobile
device to be redirected to Electrolux
Homepage.
The rating plate is located on the front
frame of the appliance cavity. You can
also download the app directly from the
app store.
2. Follow the app onboarding instructions.
3. Turn on the appliance.
4. Press . Select: Settings / Connections.
5. - slide or press to turn on or off: Wi-Fi.
The appliance wireless module starts within
90 sec.
For safety reasons, remote operation
turns off automatically after 24 h. Repeat
the onboarding, if needed.
Frequency 2.4 GHz WLAN
2400 - 2483.5 MHz
Protocol IEEE 802.11b DSSS, 802.11g/n
OFDM
Max Power EIRP < 20 dBm (100 mW )
Wi-Fi module NIUS-50
5.4 Software licences
The software in this product contains
components that are based on free and open
source software. Electrolux acknowledges the
contributions of the open software and
robotics communities to the development
project.
To access the source code of these free and
open source software components whose
license conditions require publishing, and to
see their full copyright information and
applicable license terms, visit: http://
electrolux.opensoftwarerepository.com (folder
NIUS).
10 ENGLISH
5.5 Initial preheating
Before the first use, preheat the empty
appliance.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Set the function
temperature.
Let the appliance operate for 1 h.
3. Set the function
temperature.
Let the appliance operate for 15 min.
4. Set the function
temperature.
Let the appliance operate for 15 min.
Turn off the appliance and wait until it is cold.
The appliance can emit an odour and smoke.
Make sure that the airflow in the room is
sufficient.
5.6 Setting: Water Hardness
When you connect the appliance to the mains
you have to set the water hardness level.
Use the test paper supplied with the steam
set.
Use the test paper or contact your water
supplier to check the water hardness level.
1. Put the test paper into water for about 1
sec. Do not put the test paper under
running water.
2. Shake the test paper to remove any
remaining water.
3. After 1 min, check water hardness with
the table below.
4. Set the water hardness level: Menu /
Settings / Setup / Water Hardness.
The colours of the test paper continue to
change. Check the water hardness within 1
min after testing.
You can change the water hardness level in
the menu: Settings / Setup / Water Hardness.
The table shows water hardness range (dH)
with the corresponding level of Calcium
deposit and the water classification. Adjust
the water hardness level according to the
table.
When the tap water hardness level is 4, fill
the water drawer with still bottled water.
. Set the maximum
. Set the maximum
. Set the maximum