Table of Contents
Advertisement
—
a=
G3
Ry
wo
=a
=
=o
sak
RO
shennan
eM
CREE
DEE
RCO
ERITH
I
ME
S
Display — Showing:
the selected Source: LL,
TUDE,
GRRE, UCU
PPL
VOLUME indicates the volume level.
BASS — for adjusting the bass tones
plug to this socket.
SOUTCe
systems A, B and C.
System Intelligence (ESI) system.
a
oe
Ria
| 1 : 10 : G
POWER STANDBY/OFF
e Press the POWER STANDBY/OFF key 1 to switch on the
power. The Digital System Controller will enter the standby
mode and the LED above this key lights up red.
When the DSC is switched to active mode (as described
below in the chapters 'Wake-up from standby' and 'SOURCE
SELECTION'), the respective indicators light up and the
standby indicator lights up green. When a remote control
command is received, this standby indicator flashes.
e To switch off the Digital System Controller press the
POWER STANDBY/OFF key again.
STANDBY
e Switching a set or your whole system to standby can only be
done via the remote control.
|
@ To switch a single source (e.g. TUNER) to standby:
Select the source using the source keys on the remote control.
— The selected source will be switched to standby if the
standby key is pressed briefly.
|
If the STANDBY key is kept pressed for more than approx. 1
second the whole system will be switched to stand-by.
All light indicators will be switched off with the exception of
the standby indicator (red) on the DSC.
|
When AUTO SELECT is activated the indicator of this key
also lights up during standby.
NOTE: \f the whole system is switched to standby when a
recording is active, the recording (or CD-dubbing) will be
cancelled.
8
2
Wake-up from standby
There are several options to switch your system from standby
back to operating mode:
@ Touching or turning the rotary SOURCE SELECT knob 2:
— The DSC will directly be switched to operating mode as
soan'as the SOURCE SELECT: knob:is: touched.
— When this knob is released (and not turned) all other sets in
the system (connected via the ESI sockets) become active
and all speakers in speaker system A will be activated.
= When the SOURCE SELECT knob:is touched and turned,
only the DSC, the selected source and speaker system A
will become active.
e Selecting a source with your remote control. The speakers In
the room where the remote control is used will also become
active.
e \When AUTO SELECT is activated several keys on equipment
connected via the ESI BUS sockets that activate a play
function may also be used as wake-up keys (e.g. PLAY,
SCAN;-PRESET)-
@ Pressing the DISPLAY A/B/C/OFF key 13 on your DSC.
e Pressing the SPEAKERS A, B or C key on your DSC or on
the remote control.
Advertisement
Table of Contents
