Philips DSC 950 Instructions For Use Manual page 8

7 OPERATING A SPEAKER SYSTEM
: 2 | You can connect up to 12 digital speakers to your DSC 950.
= Each digital speaker can be configured for a speaker system
_ | (A, B or C) and for a channel (left, right, mono).
' Make sure that all speakers in one room have the same
speaker system setting. This means that all soeakers in Room
A should be set to system A, all speakers in room B should be
set to system B and all speakers in room C should be set to
system C,
NOTE: Only speaker system A can be located in the same
room as your DSC 950.
Several speakers in one room can have the same channel
setting (e.g. two left and three right speakers).
Press SPEAKERS A 12 if you want to switch on speaker
system A,SPEAKERS B to switch on speaker system B and
SPEAKERS C to switch on speaker system C.
~ The display shows all settings of a particular speaker system.
Press the DISPLAY A/B/C/OFF key 13 until the required
speaker system appears in the display.
The settings of the volume, bass and treble of the selected
speaker system appear on the display.
Note: When COMPENSATION 9 is switched on, the indica-
tor above this key lights up. The bass and treble volume will
only be displayed when compensation is switched off.
You can now adjust the sound volume with the VOLUME
control 6.
Adjust the bass tones with BASS 4 and the high tones with
TREBLE 5 (only possible when compensation is switched
off)
The balance can be adjusted with the BALANCE keys on your
remote control (see also the chapter BALANCE).
e Press MUTE 9 if you want to decrease the volume by 24 dB.
Operating a speaker system via the DSC 950 remote control
¢ Since all DSS930 speakers have their own infra red remote
control sensor, you can switch on speaker system A, B and
C from any room by pointing the remote control to a speaker
and pressing the respective keys.
e The volume, bass, treble, balance and compensation of each
speaker system can be adjusted in the same way.
(see also the chapter REMOTE CONTROL.)
When the DSC950 is in standby mode, it will directly be
switched to operating mode as soon as the SOURCE
SELECT knob is touched.
When this knob is released (and not turned) all other sets in
the system (connected via the ESI sockets) become active.
The source which was selected last before the system was
switched to standby will be selected again.
When the SOURCE SELECT knob is touched and turned,
only the DSC950 and the selected source (indicated on the
alpha-numeric part of the display, e.g. Flute) will become
active.
NOTE: A selection is only made when the turning is stopped
for more than one second (to prevent that auONg turning of
the knob all sources become active).
By turning the SOURCE SELECT knob one step to the left
you select the source left to the current source.
By turning the SOURCE SELECT knob one step to the right
you select the source right to the current Source.
When AUTO SELECT is activated, you can switch both the
source and the DSC950 to active mode by simply pressing
'PLAY' on CD or Deck or one of the tuner preset keys.
Source selection via the remote control handset
Press (for more than 1 second) the respective source key
on the remote control.
The selected source and the DSC950 will become active.