Advertisement
Main Assembly
B | Print Mechanism
Character selective
@ While aligning the dowels of the character selective magnet unit with
magnet unit
the anguler holes in frames S and T, press it down carefully until the
dowels on frames S and T fit into the character selective magnet unit's
U-shaped grooves, then tighten S-4. (Screw-tightening torque: 8 kg/cm)
groove
qkpe
~ r
'. £
¥-
\
St
aie
"TAngular!
dowel
Character selective
magnet unit
Reset lever ass'y
@ Fit the two arms (S and T sides) of the reset lever ass'y onto the shaft
of the selective paw! shaft in the character selective magnet unit.
Reset lever ass'y
lecti
{
Selective paw!
shaft
Arm segment
<POINT IN DISASSEMBLY >
@ Toremove the character selective magnet unit, the reset lever ass'y must
bress the gear until it clicks into place.
Crank shaft holder
X1
Slide the holder onto the T side of the print shaft and mount it from the
W-1 (3-0.7-7.3)
X1
outside of frame T.
Make sure W-1
is correctly oriented.
Paper feeding first
Align the paper feeding first transmission gear so that it matches the
transmission gear
shape of the T end of the print shaft, then press the gear until it clicks
into place.
Advertisement
