Advertisement
7. SELF DIAGNOSTIC
Key Sequence
<P mode>
(77)--ST ALL--(Machine number)--[#/NS]
(AUTO)
(1) Display Check
|
All figures will be displayed. Make sure the
all digits and segments are displayed.
(AUTO)
(2) RAM Check
|
The RAM check result will be printed out.
(See bellows receipt sample)
(AUTO)
(8) Printing Check
|
All internal characters will be printed out.
(See bellows receipt sample)
[ST ALL] —
(4) Mode lock Check.
Turn the mode lock position from P to Z,
M, X, R and OFF.
[ST fe —
(5) Key-code Check.
Press any key except "#/NS", and "1" key.
Display shows the key-code that has been
programmed.
(See "Keyboard Programming")
[#/NS]
(6) Drawer open Check and terminate this
routine.
**+ RAM check result
(77: O.K.)
OONOOHWPD
® ASLSLS<#RBON!
+
AQLeSLc#IOR!1+0
*
7
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
x
8. ERROR CODE & MESSAGE
The machine will inform you with the following error
message on the display.
ERROR CODE
ERROR CAUSE
EO
* Is the figure entered over the capacity ?
Input Capacity
Function and Tendering key Max.8 digits
Over
Department key
Max.7 digits
Multiplication
* Quantity
Max.5 digits
* Unit price
Max.7 digits
* Product
Max.7 digits
Split pricing
* Package quantity
Max.2 digits
* Purchased quanti
Max.2 digits
* Is the amount entered over the entry limit
E2
Entry limit over
programmed ?
Operation error | * Please read this instruction manual again.
E4
*Did
you
enter
an
amount
before
Compulsory error | depression the key ?
* Did you depress [ST ALL] key before the
tendering key ?
* Did you close the drawer when operating
* Is the amount entered over the display ?
* Customer total
Max.8 digits
* Discount total
> Customer total
* Previous item void
> Customer total
* ls the key allow to operate in the R mode ?
?
E5
Amount overflow
or Negative error
E6
Prohibited
*Did you enter the correct Report ID
operation by
mode ?
programming
*Did
you
enter
the correct
machine
number ?
* Did you program the prohibit status ?
* Is the times over the programmed limit ?
Delayed receipt
E7
* Is the mode lock placed properly ?
Mode error
* Did you complete the previous operation ?
NOTE : if only certain key operation results in an
error, it may be related to your programming.
Please
confirm
the
programming
of the
associated key.
Advertisement
