Transport And Storage; Limitation Of Liability; Manufacturer's Warranty - Open System Mega Tester V4 Technical Description And Instruction Manual

select the "Span" mode. Long press the encoder button to select the type of injector
to be tested. Press the Start button.
The device sends a test signal to the nozzle and measures the gap. The gap can
be used to determine the correct tightening torque. When the measurement is
complete, press the Stop button to discharge the piezo actuator.
The device should be stored in closed, dry, ventilated rooms at a relative
humidity of up to 85% without condensation, at temperatures from -10 to +50°C and
in the absence of acid, alkaline and other active impurities in the air.
After transportation in cold weather, the product must be kept at room
temperature for at least two hours before switching on the appliance.
The manufacturer shall not be liable to the owner of this product or a third
party for damage and losses incurred by the owner or a third party as a result of
improper use of the product, including inept or erroneous actions of personnel, as
well as for losses caused by the action or inaction of this device.
Under no circumstances shall the manufacturer be liable for lost profits, lost
savings, accidental damage or other consequential economic damage, even if the
manufacturer has been advised of the possibility of such damage. The manufacturer
shall not be liable for damages claimed by you on the basis of third party claims or
caused by your failure to fulfil your obligations.
The manufacturer shall not be liable for any malfunctions or damages
resulting from the use of additional devices recommended for use with this device,
as well as its modification, repair or modification of its design not provided for in
this operating manual.
The manufacturer is not responsible for damage or loss of information, any
programs or data.
The manufacturer reserves the right to make changes to the design of the
appliance that do not impair its performance without prior notice.
The manufacturer guarantees the correct operation and compliance of the
device parameters with the technical characteristics set out in section 4 of this
document, provided that the owner complies with the conditions of transportation,
storage and operation set out in this passport.
8
"Mega Tester" Passport. Technical description

8. TRANSPORT AND STORAGE

9. LIMITATION OF LIABILITY

10. MANUFACTURER'S WARRANTY