Table of Contents
Advertisement
Issue
The drying time is too long.
Water is leaking from the
appliance.
Laundry is too damp.
Cause and troubleshooting
The lint screen is soiled.
→ "Cleaning the lint screen", Page 20
▶
The ambient temperature is greater than 86 °F (30 °C).
Ensure that the ambient temperature is below 86 °F (30 °C).
▶
The ambient temperature is lower than 59 °F (15 °C).
Ensure that the ambient temperature is above 59 °F (15 °C).
▶
Insufficient air circulation at the appliance's installation location.
Ventilate the appliance's installation location.
▶
Insufficient condensation for automatic self-cleaning when permanently drying small
loads of laundry.
Regularly dry a load weighing more than 6.6 lbs (3 kg) of damp laundry until the
▶
program ends.
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance is kept clear.
▶
The heat exchanger is soiled.
Run the basic appliance care program on the appliance.
▶
→ "Appliance care", Page 25
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 11
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected correctly.
▶
Unsuitable program for the type of fabric.
Set a timed program for subsequent drying.
▶
→ "Programs", Page 16
There has been a power failure.
Check whether the lighting in your kitchen or other appliances in the room are
▶
working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programs", Page 16 .
After the end of the program, warm laundry feels damper than it actually is.
Remove the laundry from the drum as soon as the drying program has finished.
1.
Spread out the items of laundry to cool.
2.
Unsuitable dryness level set.
→ "Changing the dryness level", Page 23 .
▶
Dryness level not adjusted.
→ "Adjusting the dryness level", Page 23 .
▶
Load too small.
Set a timed program for subsequent drying.
▶
→ "Programs", Page 16
Moisture sensor dirty.
→ "Cleaning the moisture sensor", Page 27 .
▶
The drying process is interrupted and the condensation container has been filled.
→ "Emptying the condensation container", Page 22 .
1.
→ "Inserting the condensation container", Page 23 .
2.
→ "Starting the program", Page 20 .
3.
Troubleshooting en-us
31
Advertisement
Table of Contents
