Table of Contents
Advertisement
en-us Troubleshooting
Issue
Creasing.
and program terminated.
Condensation in the condensation
container even though the water
drain hose is connected.
The program does not start.
The program duration changes
during the drying cycle.
Pumping noise.
Buzzing noise.
30
Cause and troubleshooting
The laundry lies in the drum for too long after drying.
Remove the laundry from the drum as soon as the drying program has finished.
1.
Spread out the items of laundry to cool.
2.
Unsuitable program for the type of fabric.
Set a suitable program for the type of fabric.
▶
→ "Programs", Page 16
Easy-care fabrics are dried for too long.
→ "Changing the dryness level", Page 23 .
▶
→ "Adjusting the dryness level", Page 23 .
▶
Crease-reduction function not activated.
Activate the crease-reduction function.
▶
→ "Buttons", Page 15
Condensation container filled.
→ "Emptying the condensation container", Page 22 .
1.
→ "Inserting the condensation container", Page 23 .
2.
→ "Starting the program", Page 20 .
3.
Water drain hose is caught or jammed.
Ensure that the water drain hose is not kinked or trapped.
1.
Route the water drain hose without kinks.
2.
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected correctly.
▶
Water drain hose is blocked.
Rinse the water drain hose with tap water.
▶
The filter for the condensation container is soiled.
→ "Cleaning the condensation container filter", Page 27 .
▶
The remaining volume of condensation may remain in the condensation container.
Not a fault – no action required.
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected correctly.
▶
Finish in is activated.
Check whether Finish in is activated.
▶
Control panel lock is activated.
Deactivate the control panel lock.
▶
has not been pressed.
Press
.
▶
The door is not closed.
No program has been set.
→ "Setting a program", Page 19 .
1.
→ "Starting the program", Page 20 .
2.
The program operation is optimized electronically. This may change the program
duration.
Not a fault – no action required.
▶
Condensation pump active.
Not a fault – normal operating noise.
▶
Compressor ventilation active.
Not a fault – normal operating noise.
▶
Advertisement
Table of Contents
