Table of Contents
Advertisement
TROUBLESHOOTING
CD player
Symptom
a
e@ Load the disc correctly with the label side
DOWN.
e@ Clean the dirt from the disc and then play it
again.
|Nosound
=
@
Player is in pause mode.
e
Press the PLAY or PAUSE button.
With certain discs, loud | e
Disc has bad scratch or warp.
e@ Replace the disc.
noiseis produced, orplay | @
Disc is extremely dirty.
e
Clean the disc.
e
Disc is loaded upside down.
When playback is started,
it stops
immediately.
Pauses
or stops during | e
Dirt, etc., on the disc.
playback.
Cassette tape deck
Cassette door does not | e
Deck has not stopped.
e@ Press the STOP button.
open.
e@ Power was switched off while tape was | @
Switch on power again.
Cassette door does not
running.
close.
e
Cassette tape is incorrectly loaded.
e
Reload the cassette tape correctly.
Tape does not move.
e
Deck is in pause mode.
@
Press the PAUSE or PLAY button.
e
Cassette inserted incorrectly.
e
Put cassette in holder properly.
No sound
heard
from
|e Function not set to TAPE.
e
Set to TAPE.
tape.
e
Playing unrecorded tape.
e
Play a recorded tape.
Cannot record.
'
@
Erasure prevention tabs are broken off.
| @ Apply adhesive tape over tab holes.
e
Dirty head.
e@ Clean head.
Previously
recorded
|e Dirty head.
@
Clean head.
sounds remain.
Cannot copy tape.
@
One deck has no tape loaded.
@
Load tapes in both decks.
e@
Tape in Deck Il has erasure prevention
tabs broken off.
Sound
is muffled
and | e
Dirty head.
unclear.
e@ DOLBY NR system is ON when listening
to a tape recorded without DOLBY NR.
Tape recorded with DOLBY NR but played
without.
Treble tones too strong.
Remote control unit
Batteries
are
dead
or no batteries
in
remote control unit.
@
Poor angle or too great a distance from
Remote control does not | e
work.
the remote sensor window.
e@ Thereisanobstacie between you and the
remote sensor window.
Abnormal functioning of this unit may be caused by lightning,
static electicity, or other external interference. To restore
normal operation, turn the power off and then on again, or
unplug the AC power cord and then plug it in again.
38
<RRB1089>
En
e
Use cassette that can be recorded on, or apply
adhesive tape over tab holes.
Clean head.
Use same noise reduction system for playback
as for recording. (Do not play tapes recorded
with different NR systems.)
Play in same condition as recording. (Turn on
DOLBY
NR switch for tapes recorded with
DOLBY NR.)
Insert new batteries.
Use within seven meters and within a 30
degree angle of the remote sensor window.
Change your position or move the obstacle.
Advertisement
Table of Contents
