Fisher & Paykel CG244D User Manual page 17

PROBlEM
The flame has been
blown out by a draft
or extinguished by a
spill.
The flame goes out at
low settings.
The flames are yellow
or yellow-tipped rather than
blue.
The flame pattern is uneven
around the burner.
TROUBlESHOOTING
POSSIBlE CAUSES AND SOlUTIONS
The auto-reignition feature will recognise this. The
ignitors will spark and attempt to relight the burner. If
the burner fails to relight, turn the burner off, then wait
for at least 1 minute before attempting to relight. This
is to allow for any small amount of gas that may have
escaped to disperse.
The gas supply pressure may be low. Check this with
your service person or installer.
If you use bottled gas, this may indicate you are getting
near the end of the bottle
Burner parts (especially the flame ports) may be clogged
or wet. Check that they are clean and dry.
The cooktop may have been connected to the wrong
type of gas or the gas pressure is not correct. Contact
Customer Care and do not use your cooktop until it has
been checked by a qualified technician.
Burner parts (especially the flame ports) may be clogged
or wet. Check that they are clean and dry. See 'Care and
cleaning' for instructions and illustrations on clearing
clogged flame ports. After cleaning, check that there is
flame coming out of each port.
Flame ports
Burner parts may not have been replaced correctly. Check
the assembly and make sure the burner cap and/ or ring
is sitting flat on the flame spreader. See 'Care and
cleaning' for illustrations.
Burner cap
Flame spreader
EN
1