Table of Contents
Advertisement
[ (FoR U.K. AND EUROPEAN MODELS]
CAUTION
This product contains a iaser diode of higher class than 1.
To ensure continued safety, do not remove any covers or
attempt to gain access to the inside of the product.
Refer all servicing to qualified personnel
!
t
The following caution label appears on your unit.
Location: rear of the unit
CLASS 1
LASER PRODUCT
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit.
a prece of furniture
ete., on the power cord, or pinch the cord. Never
ke a knot in the cord of te it with other cords.
The power cords
should be routed such that they are not likely to be stepped on. A
damaged power cord can cause @ fire or give you an electrical shock
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement
THE POWER
SWITCH
IS SECONDARY
CONNECTED
AND THEREFORE
DOES
NOT SEPARATE THE UNIT
FROM MAINS POWER IN STANDBY POSITION.
Information to User
Aheration or modifications carned out without appropriate authorization may invalidate the user's right to operate the equipment.
- Reorent or relocate the receiving antenna
~ Increase the separation between the equipment and receiver
~ Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These
limits are designed to provide reasonable protection
against harmful interference in @ residential installation.
This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference wili not occur in a particular installation. ff this
equipment does cause harmfu' interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures
~ Connect the equipment inte an outlet on a circuit different from that to which the receiver 1s connected.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch.U.K.,U.S. European and Australian models are
not provided with this switch.
Mains voltages in Saudi Arabia are 127V and 220V only.
Never use this model at the 110-115V setting in Saudi
Arabia.
The line voltage selector switch is on the rear panel.
Before your modei is shipped from the factory, this switch is
set to the power requirements of the destination; nevertheless,
you should check that it is set properly before plugging the
power cord into the wall outlet
1. Disconnect the power cord
2.Use a medium-size screwdriver
3.Insert the screwdriver into the groove on the
voltage
selector and adjust so that the tip of the arrow points to the
voltage value of your area
H
270.230
an
|
|
|
i
i
by
P|
| |
i
|
u ae
ates
<Round 2-pin
AC piug model>
vouraGe SeLector
<Fiat biade 2-pin
AC plug model>
3
<ARB7021>
En
Advertisement
Table of Contents
