Sony ICF-SW77 Service Manual page 7

Clock/Timer Display
Frequency Display
How to Change the MW Channel Step
i
•'j
i
(T) CLOCK indication
Flashes while setting the current time.
[D UTC indication
Appears when the current UTC (Universal Time Coordi¬
nated) time is shown.
0 STANDBY (timer standby) indication
Appears when the timer is reserved.
GO Timer numbers
Appears when each of the timers is reserved.
[H TIMER indication
Appears when the radio is activated by the timer.
(D Key protect indication
Appears when the keys are locked.
0 START TIME indication
Appears when the starting time of the timer or program
time is shown.
0 Current local time/current UTC time/starting time
® Program Time indicating bar
(1 END TIME indication
Appears when the ending time of the timer or program
time is shown.
0 TIME DIFF indication
Appears when the time difference is shown,
d Time difference/ending time/remaining time for timer and
sleep timer
d SLEEP indication
Appears when the sleep timer is operating,
d Battery empty indication
dH SYNC U/L (SYNC mode) indication
QU WIDE/NARROW (selectivity) indication
QXl Band and frequency indication
dS Station Name area
OH ON AIR indication
Appears when you receive a station during its broadcast¬
ing time (Program Time),
d SCAN indication
Appears during scan tuning,
d SIGNAL METER (signal strength meter)
@ USB/LSB/CW (SSB mode) indication
@ SYNC LOCK indication
Appears when synchronous detection is performed.
[
24
) Station selection line
@ Frequency numbers
@ AUTO TUNE indication
Appears when you set the Auto Tune function and during
Auto Tune scan tuning.
@ Page number
@ SLOW indication
Appears when you select "SLOW" for the manual tuning
interval (for AM).
The MW channel step is factory-set to 9 (or 10) kHz to match
the frequency allocation system of the country If you use the
radio where the frequency allocation system is based on a 10
(9) kHz interval, set the MW channel step selector in the
battery compartment to 10 (9) kHz by following the procedure
below.
1 Set POWER/LOCK to LOCK.
2 Open the battery compartment and'take out the batteries.
3 Set the 9 kHz/10 kHz selector to the appropriate channel
step.
4 Install the batteries and close the battery compartment.
The frequency allocation of the area
Area Frequency allocation system
North America.
South America
10 kHz step
Other countries 9 kHz step
Note
You must change the MW channel step within 5 minutes.
If more than 5 minutes elapses after the batteries are re¬
moved. the clock setting (page 9) and the data in the Quick
Page (page 13} will be erased. In this case, set them again
6
7