Sony ICF-SW77 Service Manual page 16

Example 1
If you memorize a station using manual, direct or scan tuning:
How to Erase a Frequency or a Station
Example 2
If you memorize a station using Preset Station Tuning:
Note
If you memorize a station on the Station number, the previous
station is erased and replaced by the new one.
You can erase a Station on the Tuning Page and Timer Page
by following the procedures below For the Tuning Page, you
can erase a Frequency.
1 Tune in the Preset Station to be erased. Select the Fre¬
quency also if necessary. {See pages 12. 14, 16)
2 Press EDIT.
3 While keeping TIMER CHECK/ERASE depressed, press
the Station number to be erased: SI, S2, S3, S4, or S5.
The Frequency that you tuned in in step 1 is erased.
If the Station Name has only one Frequency, that station
becomes a "Blank" station.
If the Station Name has more than two Frequencies, only the
tuned Frequency is erased and the rest remains. The Station
Name remains also.
If you want to erase all the Frequencies in the Station
Name
Repeat step 3.
When all the Frequencies are erased, the Station Name
disappears.
If there is a Preset Station with the same Station Name
After the Preset Station is erased, other Station with the same
name is tuned in so that it can be erased if you want to._
About the beep sound
A beep sound is heard when you press TIMER CHECK/ERASE to warn you that
the Station or Frequency will be erased.
24
How to Add a Frequency
You can memorize up to 10 Frequencies under each Station
Name on the Tuning Page. The Frequencies can hold some
or all of the following data:
• band and frequency of the broadcast
• AM detection mode
• Program Time (starting time and ending time)
The Station Name will be the same one as the previously
memorized station.
S Select the Page that has the Station Name to be added to
by pressing PAGE FEED + or - '
9 While keeping ENTER depressed, press the desired station
number; Si, S2, S3, S4, or S5.
The station is added as a new Frequency and will have a
Frequency number for it. {The new Frequency will be added
next to the Frequency number which was tuned in last time
under that Station )
You can save up to 162 Frequencies in total on the Tuning
Pages.
1 Tune in the desired station.
2 For AM, select the desired AM mode.
Note:
If you make a new Station Name, you cannot add it as a
Frequency; it is memorized as a new Station.
To see how many more Frequencies can be memorized
Press FREE.
"FREE" and the number of Frequencies that you can save is
displayed on the Station Name Area.
Example:
When you can save 20 more Frequencies, "FREE 20" ap¬
pears on the display.
If you do not want to program the Program Time, go to step 8.
3 Press EDIT.
"START TIME" flashes.
Press FREE again to go back to Station Name display.
4 Input the starting time by pressing DIRECT TUNE/TIME
INPUT numeric buttons. (See page 21.)
5 Press EXE.
"END TIME" flashes.
6 Input the ending time by pressing DIRECT TUNE/TIME
INPUT numeric buttons. (See page 21.)
7 Press EXE.
"START TIME" flashes again.
The Program Time duration is indicated by the Program Time
Bar on the clocMimer display.
25