Table of Contents
Advertisement
TROUBLESHOOTING
WARNING: Risk of injury! Never use a faulty appliance! To reduce the risk of shock and unintended
operation, always switch off the appliance and disconnect it from the mains before starting
troubleshooting.
Before contacting us, use the table below to check whether you can correct the problem yourself.
Problem
The vacuum cleaner
stops suddenly.
The cleaning results
are unsatisfactory
despite the
appliance working
correctly.
The cleaning results
are unsatisfactory
despite the
appliance working
correctly.
14
DIRTDEVIL.CO.UK
Possible Issue
The overheating
protection has
tripped possibly due
to blocked suction
channels, filters or
similar.
The air slide is open.
The floor tool switch
is in a position that is
not appropriate for
the floor.
Solution
1. Switch the appliance off and pull the plug
out of the socket.
2. Remove the cause of overheating e.g. by
disassembling metal telescopic tube and hose
and removing the obstacle and/or cleaning
filters.
3. Wait around 45 minutes until the appliance
has cooled down.
4. After the appliance has cooled, you may
switch it on again.
Close the air slide. (See Assembling
Your Vacuum Cleaner section for more
information.)
Adjust the position of floor tool switch. (See
Assembling Your Vacuum Cleaner section for
more information.)
Advertisement
Table of Contents
