Introduction; Specifications - AND LCM13-M Series Instruction Manual

The LCM13-M series and LCM19-M series weigh modules are composed of a beam load cell and mount
fixtures with built-in protection against horizontal and lifting forces.
The LCM13-M series and LCM19-M series are compression type weigh modules equipped with a self-aligning
function utilizing a rocker pin and are ideally suited for weighing systems used for mixing and filling.
The weigh modules are compact and lightweight and can be oriented in any direction. Therefore, they can be
installed almost anywhere.
In addition, the gaps around the stopper bolt have been adjusted at the factory for easy installation.
Rated capacity
Rated output
Maximum safe overload
Permissible horizontal force
Permissible lifting force
Maximum movable distance
Combined error
Zero balance
Compensated temperature range
Recommended excitation voltage
Maximum excitation voltage
Input terminal resistance
Output terminal resistance
Insulation resistance
Temperature effect - Zero
Temperature effect - Span
Cable
Cable color code
Load cell
Material
Mount fixtures
Accessory

1. Introduction

2. Specifications

LCM13-M sereis
1 kN, 2 kN, 3 kN, 5 kN, 10 kN,
15kN, 20 kN, 30 kN
2 mV/V±0.1%
150% of R.C.
6 kN (rated capacity of 15 kN or less)
12 kN (rated capacity of 20 kN or greater)
20 kN (rated capacity of 15 kN or less)
30 kN (rated capacity of 20 kN or greater)
3 mm (all directions)
±0.03% of R.O.
±1% of R.O.
-10°C to 40°C
5 to 12 VDC
15 VDC
380 Ω ±20 Ω
350 Ω ±3.5 Ω
5000 MΩ or greater at 50 VDC
0.016% of R.O./10°C Typ.
0.013% of LOAD/10°C Typ.
φ4 4-core shielded cable Length: 3 m With a soldered tip
Red...Excitation + (Input) Green...Signal + (output) Yellow...Shield
White...Excitation - (Input) Blue...Signal - (output)
Stainless steel
Lower mount fixture securing washer...4 pieces
10
LCM19-M sereis
5 kN, 10 kN, 15kN, 20 kN
2.0394 mV/V±0.1%
Alloy steel with nickel plating
Stainless steel