Pioneer SPH-DA77DAB Operation Manual page 58

Menu Item
[Parking Assist Guide
Adjust]
[Picture Adjustment]
[2nd Camera Input]
[On] [Off]
[2nd Camera view]
[Normal] [Reverse]
Description
1 Adjusting the guidelines by dragging or touching
/ / on the screen.
2 Touch [OK] to finish the settings.
TIP
Touch [Reset] to reset the settings.
CAUTION
• When adjusting the guidelines, be sure to park the vehicle in a
safe place and apply the handbrake.
• Before getting out of the vehicle to place the markings, be sure
to turn the ignition switch off (ACC OFF).
• The range projected by the rear view camera is limited. Also, the
vehicle width and distance guidelines displayed on the rear view
camera image may differ from the actual vehicle width and
distance. (The guidelines are straight lines.)
• The image quality may deteriorate depending on the usage
environment, such as at night or in dark surroundings.
NOTES
• This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
• Using packing tape or similar tape place markings as shown
below before setting up the guidelines so that the guidelines can
be overlaid to the markings.
• Install the rear view camera as near the centre of the vehicle as
possible, and do not install it too low. Otherwise, the guideline
comes on the edge of the screen, preventing the guideline from
being adjusted.
2 m
Markings
Markings
(page 51)
Setting 2nd camera activation.
Select the way the screen image of a camera appears.
- 58 -
50 cm
25 cm
25 cm
Rear bumper
/
MAX 2.7 m