Table of Contents
Advertisement
8 www.electrolux.com
(some units)
Press this button can select left & right swing angle.
Fan blow angle can be selected circularly as below:
no display
(stops at current
position)
N
Press this button continuously more than 2s, the
main unit will swing back and forth from left to right,
and then loosen the button, the unit will stop swinging
and present position of guide louver will be kept
immediately.
Under left and right swing mode, when the status is
switched from off to
later,
status will switch to off status directly; if
press this button again within 2s, the change of swing
status will also depend on the circulation sequence
stated above.
The function is only available for some models.
Press this button can select up & down swing
angle. Fan blow angle can be selected circularly as
below:
no display
(horizontal louvers stops
at current position)
When selecting "
fan automatically. Horizontal louver will automat-
ically swing up & down at maximum angle.
When selecting
"
er is blowing fan at xed position. Horizontal
When selecting "
blowing fan at xed angle. Horizontal louver will
Hold "
"button above 2s to set your required
swing angle. When reaching your required
angle, release the button.
, if press this button again 2s
", air conditioner is blowing
",
air condition-
、 、
、 、
", air conditioner is
、 、
N
"
"
may not be available. When air condi-
、
、
tioner receives this signal, the air conditioner will blow
fan automatically.
Press this button continuously for more than 2s, the
main unit will swing back and forth from up to down,
and then loosen the button, the unit present position
of guide louver will be kept immediately.
Under up and down swing mode, when the status is
switched from off to
later,
status will switch to off status directly; if
press this button again within 2s, the change of swing
status will also depend on the circulation sequence
stated above.
T-ON T-OFF
T-ON button
"T-ON" button can set the time for timer on. After
pressing this button, "
the word "ON" on remote controller blinks. Press
" or " " button to adjust T-ON setting. After
each pressing
" or " " button, T-ON setting
will increase or decrease 1min. Hold
button, 2s later, the time will change quickly until
reaching your required time. Press "T-ON " to
confirm it. The word "ON" will stop blinking. "
icon resumes displaying. Cancel T-ON: Under the
condition that T-ON is started up, press "T-O N"
button to cancel it.
T-OFF button
"T-OFF" button can set the time for timer off. Af-
ter pressing this button, "
and the word "OFF" on remote controller blinks.
Press
" or " " button to adjust T-OFF setting.
After each pressing
setting will increase or decrease 1min. Hold " "
or " " button, 2s later, the time will change qui-
ckly until reaching your required time. Press "T-
OFF" word "OFF" will stop blinking. "
resumes displaying. Cancel T-OFF. Under the
condition that T-OFF is started up, press "T-OFF"
button to cancel it.
N
Under on and off status, you can set T-OFF or T-ON
simultaneously.
Before setting T-ON or T-OFF, please adjust the
clock time.
, if press this button again 2s
" icon disappears and
" or "
" icon disappears
" or "
" button, T-OFF
"
"
" icon
Advertisement
Table of Contents
