Electrolux ESV093C3XB User Manual page 7

3.3 Introduction for buttons on
remote controller
N
This is a general use remote controller . It could be
used for the air conditioner with multifunction. For the
functions which the model doesn't have, if press the
corresponding button on the remote controller , the
unit will keep the original running status.
After putting through the power, the air conditioner
will give out a sound. Power indicator "
After that, you can operate the air conditioner by
using remote controller.
Under on status, pressing the button on the remote
controller, the signal icon "
remote controller will blink once and the air condition-
" "
er will give out a di
has been sent to the air conditioner.
ON/OFF
Press this button to turn on the unit. Press this button
again to turn off the unit.
MODE
Press this button to select your required operation
mode.
AUTO COOL
When selecting auto mode, air conditioner will
operate automatically according to ex-factory
. Press "FAN" button can adjust fan speed.
setting
Press " " / " " button can adjust fan blowing
angle.
After selecting cool mode, air conditioner will
operate under cool mode. Press "
button to adjust set temperature. Press "FAN"
button to adjust fan speed. Press "
button to adjust fan blowing angle.
When selecting dry mode, the air conditioner
operates at low speed under dry mode. Under
" " / " " button to adjust fan blowing angle.
When selecting fan mode, the air conditioner will
only blow fan, no cooling and no heating. Press
"FAN" button to adjust fan speed. Press "
" " button to adjust fan blowing angle.
When selecting heat mode, the air conditioner
operates under heat mode. Pre
button to adjust set temperature. Press "FAN"
button to adjust fan speed. Press "
button to adjust fan blowing angle.(some units)
" is ON.
" on the display of
sound, which means the signal
DRY FAN HEAT
" or "
" / "
" or "
NOTE
For preventing cold air, after starting up heat mode,
indoor unit will delay 1~5 minutes to blow air (actual
delay time depends on indoor ambient temperature).
Set temperature range from remote cont rolle r:
16~30 (61-86 ). Fan speed: auto, low speed,
medium speed, high speed.
FAN
Pressing this button can set fan speed circularly
as: auto (AUTO), low (
( ).
N
Unde AUTO speed, air conditioner will select proper
fan speed automatically according to ex-factory setting.
It's Low fan speed under Dry mode.
(some units)
TURBO
Under COOL or HEAT mode, press this button to
turn to quick COOL or quick HEAT mode. "
icon is dis-played on remote controller. Press this
button again to exit turbo function and "
will disappear. If start this function, the unit will run
at super-high fan speed to cool or heat quickly so
that the ambient temperature approachs the pres-
et temperature as soon as possible.
"
"
Press "
ecrease set temperature 1℃ (°F). Holding "
" " button, 2s later, set temperature on remote
controller will change quickly. On releasing button
after setting is finished, temperature indicator on
" /
indoor unit will change accordingly.(Temperature
can't be adjusted under auto mode)
When setting T-ON, T-OFF or CLOCK, press "
"
or " " button to adjust time. (Refer to CLOCK, T-
ON, T-OFF buttons)
" / " "
), medium (
Auto
/
" or " " button once increase or d
ENGLISH 7
) , high
"
" icon
" or
"