Troubleshooting - Kennedy II Commercial Series Owner's Manual

Electric fireplace with mounting bracket kit for adjustable installation
Table of Contents

Advertisement

Troubleshooting

Symptom
light is not glowing or
dimming
No warm air coming
out of appliance
Appliance turns off and
will not turn on
Remote control does
Heater shuts off
automatically
Page 24
Potential Cause
wire loosing
or wire loosing
out or wire loosing
Main circuit board burnt out or
wire loosing
Room temperature is higher
than the appliance setting (if it
is set to room temperature)
Heater is burnt out
Appliance is not plugged into
an electrical outlet or the hard
wire connections are not cor-
rect (if applicable)
and safety thermal switch has
tripped
Low battery
Room is too warm
not secured properly
Solution
necessary
necessary
necessary
Inspect the Main circuit board and re-
place if necessary
Reset temperature setting
Inspect the heater assembly and replace
it if necessary
(if applicable)
Unplug power cord and allow appliance
Inspect the circuit board and replace it if
necessary
Replace batteries in remote control
will shut off automatically once the
pre-set temperature is reached. It will
also turn on automatically if the room
temperature drops below the pre-set
temperature.
to the appliance touch panel. After 10
to reset it.
07.15.23

Advertisement

Table of Contents
loading

Table of Contents