Table of Contents
Advertisement
Fault
Special salt refill indic-
ator lights up.
Refill indicator for spe-
cial salt does not light
up.
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Display flashes.
Machine Care indic-
ator lights up.
Water is left in the ap-
pliance at the end of
the programme.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Cause and troubleshooting
Do not use special salt tablets.
▶
Water softening system is switched off.
Set the water softening system.
▶
Insufficient rinse aid.
Add Rinse aid → Page 32.
1.
Set the amount of rinse aid to be dispensed.
2.
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Arrange the tableware so that no parts project
‒
beyond the basket and prevent the appliance
door from closing properly.
Machine care is recommended.
Run the Machine Care programme without table-
▶
ware.
Use a special machine care product.
‒
The indicator will go out automatically after 3 wash
cycles whether Machine Care is carried out or not.
Filter system or area under the filters is blocked.
Clean the Filters → Page 44.
1.
Clean the Wastewater pump → Page 60.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 40
▶
Appliance functions have failed.
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.
Troubleshooting en
57
Advertisement
Table of Contents
