Safety instructions en Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power ■ that the back of the cable. dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface).
Page 6
en Safety instructions Also follow the installation Do not install the appliance ■ ■ instructions for the near heat sources (radiators, dishwasher to ensure that all heat storage tanks, cookers appliances are operated or other appliances which safely. generate heat) and do not If there is no information or if install under a hob.
Safety instructions en In daily use Warning Risk of injury! Read and observe the safety To prevent injuries, e.g. information and instructions for ■ caused by stumbling, open use on the packaging for the dishwasher only briefly in cleaning and rinsing agents. order to load and unload the dishwasher.
Page 8
en Safety instructions Ensure that children do not Warning ■ place fingers in the tablet Risk of explosion! collecting tray 1B. Small Do not add any solvents to the fingers could become caught rinsing compartment. Danger of in the slots. explosion! When opening and closing ■...
Safety instructions en Childproof lock (door lock) * Open the door with activated T he child-proof lock (door lock) child-proof lock (door lock) as D o o r l o c k protects children from potential follows: Press the catch of the hazards which the dishwasher child-proof lock to the right poses.
en Environmental protection Deactivate the child-proof lock Environmental (door lock) as follows: protection Press the catch of the child-proof lock to the right B oth the packaging of new appliances (1). E n v i r o n m e n t a l p r o t e c t i o n and the old appliances themselves Press the catch of the contain valuable raw materials and...
Getting to know your appliance en Appliance interior Getting to know your See Fig. ~ Page 2 appliance 1" Interior light * 1* Cutlery drawer * D iagrams of the control panel and the G e t t i n g t o k n o w y o u r a p p l i a n c e 12 Top basket interior of the appliance can be found at 1: Upper spray arm...
en Getting to know your appliance Overview of menu The dishwasher has been preset with certain settings for your convenience. The settings can be found in the individual chapters. You can change these factory settings. Setting up Factory setting Description •...
Water softening system/special salt en Adjusting the water softening Water softening system system / special salt You can set the amount of salt that should be added to a value between T o ensure good rinsing results, the •:‹‹ and •:‹ˆ. No salt is needed with W a t e r s o f t e n i n g s y s t e m / s p e c i a l s a l t dishwasher requires soft water, i.e.
en Water softening system/special salt Using special salt Using detergent with a salt component Top up the special salt as soon as the I n general, you can use detergent with salt refill indicator @ lights up in the D e t e r g e n t w i t h a s a l t c o m p o n e n t a salt component up to a water control panel.
Rinse aid en Setting amount of rinse aid Rinse aid You can set the amount of rinse aid that should be added to a value between The rinse aid ensures stain-free dishes R i n s e a i d and clear glasses.
en Utensils Using detergent with a rinse Glass and utensil damage aid component Causes: I n general, you can use detergent with Glass type and glass production ■ D e t e r g e n t w i t h a r i n s e a i d c o m p o n e n t a rinse aid component up to a water process.
Utensils en Upper basket Lower basket Arrange cups and glasses in the upper Arrange pots and plates in the lower basket 12. basket 1j. * depending on the features of your * depending on the features of your dishwasher dishwasher Utensils must not be placed Heavily soiled utensils (pans) Note:...
en Utensils Cutlery basket * You can take out the cutlery drawer. P lace cutlery, always unsorted with the C u t l e r y b a s k e t tips face down, in the cutlery basket *. To prevent injuries, place long, pointed implements and knives on the knife shelf *.
Utensils en Etagere * Folding spikes * T he etagere and the space underneath * Depending on the features of your E t a g e r e F o l d i n g s p i k e s can be used for small cups and glasses dishwasher, the spikes can be folded or for larger items of cutlery, such as...
en Utensils Knife rack * Baking sheet spray head * * Depending on the features of your * depending on the features of your K n i f e r a c k B a k i n g s h e e t s p r a y h e a d dishwasher, the upper basket is fitted dishwasher with a knife shelf.
Utensils en Unloading the dishwasher Appliance height 86.5 cm With cutlery basket Upper Lower To prevent water from dripping off the basket basket upper basket onto the utensils in the Setting 1 max. ø 24 cm 34 cm lower basket, it is recommended to empty the appliance from the bottom Setting 2 max.
en detergent Upper basket with side levers Detergent Pull out upper basket 12. Y ou can use tablets as well as powder Hold the sides of the basket along d e t e r g e n t or liquid detergents for dishwashers, but the upper edge.
detergent en Adding detergent If the utensils are only lightly Tip: soiled, slightly less than the indicated amount of detergent is usually If the detergent dispenser 9* is still adequate. closed, actuate locking bar 92 to Suitable detergents and care products open it.
Page 24
en detergent Even if the rinse-aid and/or salt refill Notes ■ If you want to add more utensils after indicator is lit, the rinse programme ■ the programme has started, do not will run correctly with combined use the tablet collecting tray 1B as detergents.
Overview of programmes en Overview of programmes T he max. possible number of programmes is illustrated in this overview. The O v e r v i e w o f p r o g r a m m e s corresponding programmes and their arrangement can be found on the fascia.
en Overview of programmes Type of dish Type of soiling Programme Possible Programme sequence additional options Time-optimised: part dried, common Cleaning 65° Œ mixed utensils Extra Dry household food Intermediate rinse and cutlery Shine and Dry 65° remnants Final rinse 70° Drying sensitive Time-optimised:...
Additional functions en Ï intensiveZone * Additional functions P erfect for a mixed load. You can wash i n t e n s i v e Z o n e very soiled pots and pans in the lower * Depending on the features of your A d d i t i o n a l f u n c t i o n s basket together with normally soiled dishwasher, you can select different...
en Operating the appliance Switching on the appliance Operating the Turn tap fully on. appliance Switch on ON/OFF switch (. The Eco 50° programme has been P rogramme data preset for environmentally friendly O p e r a t i n g t h e a p p l i a n c e operation whenever the appliance The programme data (consumption starts.
Operating the appliance en timeLight (optical display infoLight (optical display while while a programme is a programme is running) * running) * * depending on the configuration of i n f o L i g h t your specific dishwasher * depending on the configuration of t i m e L i g h t your specific dishwasher...
en Operating the appliance Remaining running time Programme end display The programme has finished when the value ‹:‹‹ appears in the display When the programme is selected, the window h. If a value has been set for remaining programme time is indicated the signal volume, then the end of the in the display window h.
Operating the appliance en Auto Power Off (Automatic Here is how to change the setting: Switch on the ON/OFF switch (. switch-off after end of Hold down the programme button programme) or interior # and then repeatedly press the lighting * START button ` until •:‹...
en Operating the appliance Interrupting the programme Changing the programme When the START button ` has been Caution! pressed, the programme cannot be Expansion (overpressure) may cause changed. The only way a programme the appliance door to jump open and/or can be changed is by Cancel water to escape! If the door was opened programme (Reset).
Cleaning and maintenance en Notes Cleaning and Only clean the appliance with ■ special detergents/appliance maintenance cleaners which are suitable for use with dishwashers. A regular inspection and maintenance Regularly wipe the door seals using C l e a n i n g a n d m a i n t e n a n c e ■...
en Cleaning and maintenance ‰ Special salt and rinse aid Machine Care M achine Care used in combination with Top up the salt and/or rinse aid as soon M a c h i n e C a r e commercially available machine as either of the refill indicators on the cleaning detergent is a suitable control panel @ or H lights up.
Cleaning and maintenance en Spray arms After each washing cycle check the filters for residue. Limescale and contaminants in the Unscrew filter cylinder as illustrated rinsing water may block nozzles and and take out filter system. bearings on the spray arms 1: and Check outlet nozzles on the spray arms for blockages.
en Fault, what to do? Clean the waste water pump as Fault, what to do? follows: Disconnect the dishwasher from the E xperience has shown that you can power supply. F a u l t , w h a t t o d o ? rectify most faults which occur in daily Take out top basket 12 and bottom operation yourself.
Fault, what to do? en Fault table Fault Reason Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display lights up. Tap turned off. Turn on water supply. Tap jammed or calcified. Turn on water supply. Flow rate must be at least 10 l/min.
Page 38
en Fault, what to do? Fault Reason Remedial action Fault code “:ƒ… is lit. Waste-water hose kinked or Install hose without kinks, remove any blocked. residue. Siphon connection still sealed. Check connection to siphon and open if required. Cover on the waste water pump Lock cover correctly.
Page 39
Fault, what to do? en Fault Reason Remedial action Utensils not dry. Not enough rinse aid in the Refill rinse aid. dispenser, or none at all. Programme without drying was Select programme with drying. selected. ~ "Overview of programmes" on page 25 Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 40
en Fault, what to do? Fault Reason Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 41
Fault, what to do? en Fault Reason Remedial action Detergent residue Detergent dispenser cover 9* Utensils must not be placed above the blocked by utensils and therefore tablet collecting tray 1B. These may does not open fully. block the lid of the detergent dispenser and prevent it from opening fully.
Page 42
en Fault, what to do? Fault Reason Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than 8.9...
Page 43
Fault, what to do? en Fault Reason Remedial action Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing temperature. Utensils precleaned too intensely; Do not prerinse utensils. Remove only sensors therefore decide on large food remnants. weak programme sequence. Increase sensitivity of the sensors.
Page 44
en Fault, what to do? Fault Reason Remedial action Appliance cannot be Malfunction. Disconnect appliance from the power switched on or operated. supply; pull out the mains plug or switch off the fuse. Wait at least 5 seconds, then connect the appliance to the power supply.
Page 45
Fault, what to do? en Fault Reason Remedial action Filling valves making Depends on domestic installation, No remedial action possible. striking noises. as no appliance fault. No effect on appliance function. Knocking or rattling noise. Spray arm strikes the utensils, Position utensils so that the spray arms do utensils not positioned correctly.
en Customer service Customer service Installation and connection I f you are unable to rectify the fault, C u s t o m e r s e r v i c e please contact your customer service. T he dishwasher must be connected We will always find an appropriate I n s t a l l a t i o n a n d c o n n e c t i o n correctly, otherwise it will not function...
Installation and connection en Delivery Installation Your dishwasher has been checked The required installation dimensions thoroughly in the factory to ensure that can be found in the installation it is in working order. This may cause instructions. Level the appliance with small water stains.
en Installation and connection Drinking water connection Warm water connection* * depending on the configuration of Fasten the drinking water connection H o t w a t e r c o n n e c t i o n your specific dishwasher to the tap according The dishwasher can be connected to to the installation instructions using...
Installation and connection en Electrical connection Transporting Empty the dishwasher and secure loose Connect the appliance to an ■ parts. alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz Drain the appliance according to the via a correctly installed socket with following steps: protective earth conductor.