Table of Contents
Advertisement
Fault
Detergent residue in
the appliance
Water marks on
plastic parts.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Cause and troubleshooting
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
Select a more intensive Programme or use Powder
▶
detergent.
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
Change your detergent → Page 33.
▶
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arrange tableware", Page 37
Use rinse aid.
▶
→ "Rinse aid", Page 32
Set the water softening system higher.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent.
▶
Clean the appliance mechanically.
▶
White coating is deposited in the appliance interior.
Set the water softening system correctly.
1.
In most cases you will need to increase the setting.
Change your detergent if required.
2.
Special salt dispenser is not screwed tight.
Screw the special salt dispenser tight.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent.
▶
Clean the appliance mechanically.
▶
Hardness range is set incorrectly or the water hard-
ness is too high.
Set the Water softening system → Page 29 to the
▶
water hardness or add special salt.
3in1/organic/eco detergent is not effective enough.
Set the Water softening system → Page 29 to the
▶
water hardness and use separate detergents (pro-
prietary detergent, special salt, rinse aid).
Too little detergent is being used.
Troubleshooting en
53
Advertisement
Table of Contents
