Technics SA-DX930 Operating Instructions Manual page 18

ROT4918
POWER
(C)
o/| N
s €* 5» é 9 9 9 n è >ù © 9" 9 9 n 5» 9 ER 9 A R 9? 9€" ee
ASPEAKERS B
O O
L— SETTING —
"SPEAKEAS-
-DO
€ *9 @ . * ¢ b . .* @ * €" @ b . * o è * ò è t oe * è *
INPUT SELECTOR
[28
7i
d
a
Selected source
. 3 . se LI 2 a * ." € * L] se 9 aù 5» o 9 9? @ 5» @ 8 .
TINIE Cd
P CH MET LAL
s. ų k è o ò 9 © ò # €9 ò 5» B é o @ 5» G n òa B $9 8 $9 'l
VOLUME
Before operation, set VOLUME to the "MIN" position.
1 Press [POWER].
Press [A] and/or [B] to select the speaker
system(s) to be used.
A and B refer to the speaker terminals at the rear of the unit.
if the button is pressed once more, the indicator will switch
off and no sound will be heard from the speakers.
Turn [INPUT SELECTOR] to select and start
the desired source.
(Refer to the appropriate operating instructions for details.)
The indicator corresponding to the selected source lights and
the source is shown on the display.
TAPE (MONITOR): To listen to cassette tapes
VCR: To watch video tapes
TV/DSS: To watch TV or DSS
DVD: To watch DVD
CD: To listen to compact discs
TUNER: To listen to radio broadcasts
PHONO: To listen to phono discs
To watch a video (or DVD) or the TV, set the TV to either the
TV mode or VIDEO mode.
(only if you select TV/DSS, CD or DVD in the above step)
Press [DIGITAL INPUT] to select "DIGITAL" or
"ANALOG".
Switches between "DIGITAL" and "ANALOG" each time the
button is pressed.
The "DIGITAL INPUT" indicator lights when DIGITAL
selected.
Adjust the volume level.
. . . . * * . *. b . * a * * . * * + . «a . * a . LI . . a +
For your reference
* If the SURROUND, DTS or SFC mode has been selected
After displaying the selected source, the display will then
change to show the SURROUND, DTS or SFC mode.
(=> page 24-25)
lf the source chosen was TUNER then the display will change
again to show the frequency.
€ If you are using VCR and you select TAPE, CD, TUNER, or
PHONO
The picture will remain on the screen.
When you finish listening
Be sure to reduce the volume level, and switch the power to the
standby condition by pressing [POWER].