Table of Contents
Advertisement
Troubleshooting / Recycling and disposal
EN
EN
Troubleshooting
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Unsatisfactory
working result
Recycling and disposal
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
For further information visit www.recycle-more.co.uk.
The product comes in a package that protects it against damage during shipping.
Keep the package until you are sure that all parts have been delivered and the
product is working properly. Recycle the package afterwards.
18
MNL_Greatstar_25W Glue Gun_V2_230524.indd 18
Possible cause
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect
to the product
2.1. Extension cord is not
suitable for operation
with this product
2.2. Power source (e. g.
generator) has too
low voltage
3.1. Adhesive areas are
not pre-treated
3.2. Glue stick is not
suitable for workpiece
material
TTB956GLG by TITAN
Solution
1.1. Connect to power supply
1.2. Have the product checked
1.3. Have the product checked
2.1. Use a proper extension
cord
2.2. Connect to another power
source
3.1. Clean and rough the
adhesive areas
3.2. Use glue stick that is
suitable for the surface
being glued
5/26/23 12:26 PM
Advertisement
Table of Contents
