Table of Contents
Advertisement
Operation
EN
EN
Glue operation
1.
gun.
2. Slide a glue stick (7) in the feed channel (2) until it stops.
3. Connect the plug of the power cord with a suitable power socket.
WARNING! Check the voltage! The voltage must comply with the
information on the rating label!
4. The hot glue gun will automatically turn on when connected to the power
supply.
NOTE: The adhesive will soon harden. It is important to quickly bond
materials together. Press them together for approximately 30 seconds.
After about 5 minutes, the bonding area becomes elastic. Please note
that this information depends on temperature and material.
5. Fold the stand holder (6) up if not
required.
6. Always hold the main grip (3) and
point the nozzle (1) of the glue gun
on the surface to be processed and
apply the glue by keeping the trigger
(5) pressed evenly. Repeat this
step as needed. If it becomes hard
to squeeze more glue out, just wait
15 seconds for the new section of
glue to melt in the feeding channel
(2) (Fig. 5).
NOTE: When the glue stick is worn out so that it cannot be pushed
further into the nozzle (1) with the trigger (5), insert a new glue stick
with the same type behind it, the new glue stick will push the used one
further forward by pressing the trigger (5). Do not try to remove the
used glue stick from the feeding channel (2). Once used, a glue stick
(7) must be used up completely.
7. If you need to put the glue gun down, always ensure you unfold the stand
holder (6) and place it on a level heat proof surface.
8. Put a heat proof tray (not supplied) under the nozzle to collect glue drops.
14
MNL_Greatstar_25W Glue Gun_V2_230524.indd 14
2
1
6
Fig. 5
TTB956GLG by TITAN
7
5
3
5/26/23 12:26 PM
Advertisement
Table of Contents
