Advertisement
Preparing the Cabinet
■ Determine the precise location of
your wall oven according to the
installation instructions that came
with your appliance.
■ Once the hole is cut for the wall
oven, determine the location for the
Shabbos Keeper RJ45 cable by
measuring back from the front of the
opening by a minimum of 20" and
an inch below the top of the step.
The connection for the RJ45 cable
is located on the rear of the "step"
on the oven. You will want to locate
the hole between the "step down"
on top of the wall oven and the rear
of the oven as not to interfere with
the highest portion of the oven.
Connecting RJ45 Cable
■ The unit is shipped with the cable connector available for
the RJ45 cable.
■ To expose the connection, remove the screw from the
black bracket on the "step' of the rear of the wall oven.
■ Gently pull out the bracket to expose the RJ45
connector.
■ Use one of the supplied adhesive strips to secure the
bracket to the top of the step-down portion of the oven.
Installing Shabbos Keeper to
GE Appliances Wall Oven
RJ45 cable
Hole cut for
wall oven into
attached to
cabinet.
the rear of
the "step".
■ Reinstall the screw removed earlier from the bracket.
This screw will overlap the bracket and help to secure it
to the oven.
■ Insert the supplied RJ45 cable into the connector.
■ This cable will be pulled through the drilled hole in the
cabinet when the wall oven is installed. Once the cable is
through the hole, connect the Shabbos Keeper module.
Note: The hole must not force the RJ45 connection to
bend more than 30 degrees from straight.
■ This module can be mounted with the supplied adhesive
strips to the inside of the cabinet where the hole was cut
or may be left on the shelf.
■ For instructions for use, see your appliance Owner's
Manual and/or the manual supplied with the Shabbos
Keeper.
Locate hole for RJ45
cable so it is in this area
will be
49-2001303 Rev. 0 08-23 GEA
Advertisement
