Table of Contents
Advertisement
Status LED
After the sonar module is installed, it turns on when the chartplotter is turned on. The status LED on the sonar
module indicates its operational status.
LED Color
State
Red
Solid
Green
Flashing
Red
Flashing
Orange
Flashing
Red/Green
Flashing
Red/Orange Flashing
Flashes twice followed by a 3-
Red
second pause
Flashes three times followed
Red
by a 3-second pause
Flashes four times followed by
Red
a 3-second pause
Flashes five times followed by
Red
a 3-second pause
Specifications
Size
Weight
Case material
Water rating
Temperature range
Power input
Power usage
Fuse
Compass safe distance
Sounder power
Frequency
Depth
Data output
2
The device withstands incidental exposure to water of up to 1 m for up to 30 min. For more information, go to www.garmin.com/waterrating.
3
Dependent on transducer rating and depth.
4
Maximum depth dependent on transducer, water salinity, bottom type, and other water conditions.
Status
The sonar module is booting.
The sonar module is connected to a chartplotter and is
operating properly.
The sonar module is turned on, but is not connected to a chart
plotter, or is waiting to connect to a chartplotter.
A software update is in progress.
The sonar module is in test mode.
The sonar module terminal block lid is open.
Other sonar failure. Check all connections.
The transducer is not detected by the sonar module.
The sonar module input voltage is below the minimum required
input voltage.
The sonar module input voltage is above the maximum allowed
input voltage.
L x W x H: 270.65 x 366.55 x 101 mm (10.66 x 14.43 x 3.98 in.)
6.41 kg (14.125 lb.)
Fully gasketed, aluminum and steel housing with plastic access panel .
2
IEC 60529 IPX7
From 5 to 158°F (from -15 to 70°C)
From 10 to 32 Vdc
120 W max.
15 A (fast-acting, blade type)
190 cm (75 in.)
From 25 to 3,000 W (RMS)
From 25 to 250 kHz (dependent on transducer)
4
3,048 m (10,000 ft.)
Garmin BlueNet network
3
11
Advertisement
Table of Contents
