Subnetwork Health And Status Messages - Paradyne COMSPHERE DualFlow 3615 User Manual

COMSPHERE DualFlow Data Service Units
Message
Devic
DialBU
DialCN
DialTn
Disab
DTR
ExtLd
Facil
NoResp
Normal
RPower
Stndby
Stream
SubSpd
Test
Thresh
TribTm
Trunc
C-8
Table C-5

Subnetwork Health and Status Messages

TDM/Flex only: Device Failure. One of the following major alarms is in effect:
Configuration Corrupt
Device Test Failure
Dial mode. Indicates that the DBM is active.
Dial Connect. Indicates that the DBM is in Standby mode.
Dial Tone Test failure.
Indicates that the DSU or DBM is disabled.
DTE alarm. Data Terminal Ready lead is Off.
External lead alarm A or B.
DDS facility alarm. Indicates a network facility alarm.
The active poll list member did not respond. Probable cause: a facility problem, a
remote DSU problem, or an incorrect poll list.
Active poll list member does not report an alarm or its status.
Redundant power supply alarm.
DBM is in Dial Standby.
Streaming terminal.
Subnormal operating speed.
Test mode. It could be a DSU or DBM test.
Threshold is exceeded.
Tributary time-out. Tributary is not answering polls.
Subtree truncation. More information is being received than can be returned in the poll.
You must access each tributary for its messages.
July 1999
Condition
3615-A2-GB20-40