Samsung UN46B8000XFXZA Service Manual page 53

4. Troubleshooting
Pairing the remote control failed.
The remote control does not work
after pairing is completed.
The find remote control function
does not work.
4-8
1. The remote control must be less than 1 meter from the TV.
2. Check if the TV power cord is connected.
3. Check if the following pairing procedures are kept.
1) Press the Pairing key on the remote control.
2) Set the Picture OFF setting of the TV to Picture ON.
3) When the TV OSD is displayed, press the OK button.
1. Press the Reset button at the bottom of the remote control.
RF Remote Control
2. Replace the batteries. (When replacing them, make sure to insert
them according to the correct polarities.)
1. Check if find remote control mode has been set.
2. Press the Reset button at the bottom of the remote control.
(If you press the Reset button, you have to set it to find remote
control mode again.)
3. Replace the batteries. (If you have pressed the Reset button,
you have to set it to find remote control mode again.)