Table of Contents
Advertisement
ENGLISH
Rear Panel Audio and System Connections
@ Tuner: Connect the output of an
AM/FM tuner to these jacks.
@® CD: Connect these jacks to the
output of a compact disc player or
CD changer.
@ Tape 1 In: Connect these jacks to
the PLAY/OUT jacks of an audio
recorder.
@® Tape 1 Out: Connect these jacks
to the RECORD/INPUT jacks of an
audio recorder.
@ Tape 2 In: Connect these jacks to
the PLAY/OUT jacks of a second
audio recorder.
@ Tape 2 Out: Connect these jacks
to the RECORD/INPUT jacks of a
second audio recorder.
© Main Amp In: These jacks con-
nect the output of an external pre-
amp to the unit's power amplifier. In
most normal use they are connected
via jumpers to the AVI250's Pre-
Outs @.
@ Pre-Outs: If external power
amplifiers are used for any channels,
remove the connection pin and con-
nect the jack to the input of the
amplifier.
@ Subwoofer Pre-Out: Connect
this jack to the line level input of a
powered subwoofer. If an external
subwoofer amplifier is used, connect
this jack to the subwoofer amplifier
input.
@ 6-Channel Direct Inputs: If an
external digital audio decoder is
used for 5.1 (Dolby AC-3) audio,
connect the outputs of that decoder
to these terminals.
6
@ Front L Speaker: Connect these
terminals to the front left speaker.
@ Front R Speaker: Connect these
terminals to the front right speaker.
@ Surround L Speaker: Connect
these terminals to the left surround
speaker.
@ Surround R Speaker: Connect
these terminals to the right surround
speaker.
@ Center Speaker: Connect these
terminals to the center speaker.
@ Multi Room Interface: For multi-
room installations where keypad
remotes are in use, connect the key-
pad interface to this jack.
® Multi IR: Connect the output of
an IR sensor in a remote room to this
jack to operate the multi-room con-
trol system.
@ Multi-Out: When using the AVI
250 for multi-room audio, connect
this jack to the input of the audio
amplifier powering the remote room
speakers.
© Power Cable: Connect the AC
plug to a non-switched AC wall
output.
@ Switched AC Outlet: This outlet
may be used to power any device
that you wish to have on when the
unit is turned on.
@ Unswitched AC Outlet: This out-
let may be used to power any AC
device. The power will remain on at
this outlet regardless of whether the
AV1250 is on or off.
NOTE: The power consumption of
the device plugged into each of
these outlets should not exceed 120
watts.
@ Remote IR In: If the AVI250's
front panel IR sensor is blocked due
to cabinet doors or other obstruc-
tions, an external IR sensor may be
used. Connect the output of the sen-
sor to this jack.
@) Remote IR Out: This connection
permits the IR sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the "IR
IN" jack on Harman Kardon or other
compatible equipment.
Advertisement
Table of Contents
