Table of Contents
Advertisement
The unit is well ventilated in itsclf, but sufficient space must be allowed
around it to permit proper air flow. Install the amplifier in a manner to allow for
unrestricted circulation. Do not pkice books or other objects on the cage or in
the immediate vicinity of the instrument.
Reducing the air flow will result in
sharply reduced component and tube life.
Power Requirements:
Plug the AC cord into any outlet furnishing LIT volts 50 or 60 cycle AC oir-
rent. The voltage may vary between 15 and 125 volts. Two AC convenience
outlets are located on the rear of the instrument. Auxiliary apima {tape deck,
record player, additional amplifier) may be plugged inte these outlets and will
be controlled by the on/olf switeh located on the A-224,
REAR PANEL CONNECTIONS
= LEFT SArARcAS
EHT
giha FAR
| Deae
| 2Qaeae e@ |
a
è
ü
if
IË
5
E
E
Wf
Tare
(js)
oH
AEAN
PÄHEL
HOOTL
Ane
Connecting Your Speakers:
Your two speakers should be matched if possible to obtain optimum results
and should be placed approximately & to 15 feet apart a
one wall of your
listening room. Corner placement is also quite acceptable. Facing the speakers
straight out or slanting them slightly
will depend om your room size, scoustle
effect and where you will be seated for listening. It may be mecessary to experi-
ment with speaker placement tatil best results are obtained.
Use any type wire to commect your speakers, Lamp cord is excellent and muy
be eusily dressed around the molding for an inconspicuous and neat installation.
Normal Stereo Speoker Arrangement:
Connect one lead from the left speaker te the 16 ohm terminal on the LEFT
SPEAKER output strip and the other lead to the A or B terminal on the same
strip. Now connect one of the leads from the right speaker to the LA ohm term-
inal on the RIGHT SPEAKER
output strip and the other lead to the A or B
terminal on the same strip. NOTE: A and B terminals on both SPEAKER output
strips are strapped together at the factory and should be allowed to remain
strapped for this method of steren speaker connection.
(Sec Dingram A) The
output terminals nsed should be those marked with the same impedance as the
speakers, The above illustration is for 16 ohm speakers, If you are using § ohm
speakers connect to the 4 ohm SPEAKER output terminals rather than to the
16 ohm terminals.
Advertisement
Table of Contents
