Harman Kardon AVI 250 Owner's Manual page 21

ENGLISH
1 No more than 2 mete t<-When rear-mounted 4 1 Speakers are used
TV or Projection Screen
Lett Front "Center Front. ~ Right Front
Speaker Speaker peaker
Optional Rear Wall Mounting
System Configuration
16
Surround speakers should be placed on
the side walls of the room, at or slightly
behind the listening position. The center
of the speaker should face into the room
with the active speaker drivers pointing
towards the front and rear of the room.
The speakers should be located so that
the bottom of the cabinet is at least 60
centimeters higher than the listeners'
ears when in the desired area.
If side wall mounting is not practical, the
speakers may be placed on a rear wall,
behind the listening position. Again, they
should be located so that the bottom of the
cabinet is at least 60 centimeters higher
than the listeners' ears. The speakers
should be no more than 2 meters behind
the rear of the seating area.
Subwoofers produce non-directional
sound, so they may be placed almost
anywhere in a room. Subwoofer place-
ment is highly influenced by room size
and shape, and the type of subwoofer
used. Follow the instructions of the sub-
woofer's manufacturer, or experiment
with the best location for a subwoofer in
your listening room.
Once the speakers have been placed in the
room and connected, the final step is to
enter the configuration information and
balance the speaker output levels. Before
proceeding further this is a good time to
review the installation section of the
manual to make certain that all connec-
tions are properly made.
System Settings
1. Plug the unit into an AC wall outlet
and press the Power button on either
the front panel {{ or the remote @.
Note that the ring surrounding the front
panel switch will turn green, and the
front panel display will illuminate.
2. Check to see that the unit is configured
to the video broadcast standard in use in
your country by pressing and holding the
OSD button on the front panel fi] for
more than three seconds. The front panel
display will indicate the current setting.
If the setting is not correct, press the but-
ton again until the correct standard
(PAL, SECAM or NTSC) is displayed.
3. Turn on the TV connected to the
receiver. Select the appropriate video
input on the TV.
NOTE: Although the unit will switch "S"
video signals, the on screen menus con-
trol system is NOT visible on the S video
output.
4, Press the SCREEN DISPLAY
button, and then press any of the naviga-
tional arrow buttons or the SELECT
@® button on the remote to bring the
MAIN MENU up on your video screen.
(Figure #1)
5. Press the w button until the on screen
> cursor is pointing fo SET UP MENU.
6. Press SELECT €3 to move to the
next screen, SET UP MENU 1.
(Figure #2).
7. The first item to be set is the Center
Channel Mode. The on screen > cursor
will already point toward this option
when you select the menu. Press the
or p> buttons ¢% to choose one of
these center channel options by moving
the cursor:
LARGE: Choose this option if you are
using either a THX Certified speaker