Table of Contents
Advertisement
c. When VCR 1 or VCR 2 is the input
source, these buttons switch
between VCR and TV as the unit's
output.
d. When TV is the input source,
these buttons may switch
between video input sources or
antenna/video, depending on the
TV model.
e. When LD is the input source,
these buttons will switch the side
being played from "A" to "B" on
compatible dual side players.
f. When TUNER has been selected,
these buttons will change the
frequency band.
@® Number Keys: These buttons
serve as a ten bution numeric key-
pad to enter tuner preset positions
or station frequency. They are also to
be used to select channel numbers
when TV has been selected on the
remote, or to select track numbers
onacCbD or LD player, depending on
how the remote has been pro-
grammed. The letters below the but-
tons are used to enter information for
tuner station names.
@® P-Scan: Press this button to
automatically scan through the sta-
tions preset into the memory of a
compatible tuner.
Remote Control Functions
9
@® Memo: The memo button is used
to enter stations to a compatible
tuner's preset memory in either the
manual or automatic modes.
@ Delay: This button controls the
amount of sound delay to the rear
(surround) channels. Press it to
increase the delay in the steps shown
in the main Information Display or
on-screen graphics.
@ Menu Controls: These buttons
control the action of the cursor or the
selection of menu items when the
unit is being configured using the
setup menus.
@ Select: This button enters set-
tings to the unit's memory during
system configuration.
@ Screen Display: Press this but-
ton to activate the on screen menu
system.
@) Panel Display: Press this button
to turn off all displays and indicators
in the Information Display except for
asmall
D TSP
indication in the
lower right corner of the display @
Press the button again to turn the
display back on. Note that the dis-
play will briefly illuminate when a
command is sent to the unit from the
front panel or remote, even though
the display is turned off.
@) Test Noise: Press this button to
begin calibration of the output level
for each channel. A test signal will
immediately be heard from the left
front speaker and the TEST
indica-
tor @ will flash.
HSII
@® Speaker Select: When setting
the system output levels, this button
selects the speaker position being
adjusted. Press it once to advance
to the next speaker after each posi-
tion is adjusted.
@
Level Adjust: When setting the
system output levels, press these
buitons to increase or decrease the -
output level.
@) Sending LED: This indicator
should flash any time a button is
pressed to confirm that a command
is being sent. If the light is dim or
does not illuminate when a button is
pressed the batteries in the remote
should be replaced.
@} Learn LED: This indicator will
illuminate when a button on the
remote is being programmed with
signals from another remote during
the "learning" mode. The light will go
out when the signal is received and
memorized.
9 6 Channel Direct: Press this but-
ton to select the output of an exter-
nal multichannel audio adapter.
Advertisement
Table of Contents
