Table of Contents
Advertisement
INPUT SELECTION: After reaching
the INPUT
SELECTORmenu
(Figure #13), use the arrow keys on the
remote ¢ to select the desired input.
Remember that when a split listening
session is desired, select the VIDEO
source first, followed by the AUDIO
source. To use the Tape Monitor, press the
down arrow button W @ to move the
on-screen cursor. Use the <{ and >
arrow buttons to turn the Tape Monitor
On or Off.
RECORD OUT SELECTION:
After
reaching the REC OUT SELECTOR
menu (Figure #14) use the navigational
arrow keys to select the input to either
TAPE
lorVCR
1. Note that if the
current main input
SOURCE
is chosen,
two more lines will appear on the screen
to remind you which audio and video
sources are selected. (Figure #15).
SURROUND MODE: After reaching
the SURROUND
MODE menu (Figure
#16), use the navigational arrows € to
select the desired mode. When a mode is
selected that uses the surround channels,
you may change the rear channel
DELAY TIME at this menu.
On Screen Display
23
TEST TONE: At this menu you may
adjust the speaker output levels. For
information on this procedure, refer to
the System Configuration section of this
Manual.
MULTI-ROOM
SEL: For information
on configuring and using the multiroom
audio functions of the AVI250, consult
the appropriate section of this Manual.
SET UP MENU: For information on
using the Set Up menus, refer to the
System Configuration section of this
Manual.
HS!ON
SELECTOR
REC
OUT
>TAPE
*SOURCE®*
VCRL
*SOURCE*
AUDIO
*TUNER*
VIDEO
*LD*
RETURN
TO
MAIN
MENU
Figure 15
SURROUND
MODE
>MODE
THX
CINEMA
DELAY
TIME
:20ms
RETURN
TO
MAIN
MENU
Figure 16
Advertisement
Table of Contents
