Installing The Dsu; Hardware Settings - Paradyne COMSPHERE 3610 Quick Reference Manual

Installing the DSU

The Model 3610 DSU is designed for desktop operation.
H
Place the DSU in the planned location.
H
Allow 1 to 2 feet of clearance for cable connections, space for the ventilation slots
on the sides, and clearance at the rear for the cable connections.

Hardware Settings

!
HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from
damage due to electrostatic discharge (ESD) during normal
operation. When performing installation procedures,
however, take proper static control precautions to
prevent damage to equipment. If you are not sure
of the proper static control precautions, contact
your nearest sales or service representative.
TDM/Flex and MCMP/Flex models are available with two or six ports. When your
firmware version is 6.33 or greater, each port can be set individually for either EIA-232
or V.35 using the front panel, an async terminal, or an NMS.
Based on your model, you may need to perform one of following procedures. Use ID
from the Status branch to obtain the firmware version.
If your And the
model is a EIA-232
6-port . . . setting . . .
Is correct
TDM/Flex or
MCMP/Flex MCMP/Flex
with firmware
Needs to be
6.33 or
changed
greater
Is correct
TDM/Flex or
MCMP/Flex MCMP/Flex
Needs to be
with firmware
changed
less than
6.33
Is correct
TDM/DSD or TDM/DSD or
Needs to be
MCMP/DSD
changed
Then . . .
Go to Powering Up the DSU , page 9.
Go to Powering Up the DSU , page 9, and
Reconfiguring Ports , page 10.
Go to Powering Up the DSU , page 9.
Change the S1 switch setting on the TDM/Flex or
MCMP/Flex circuit card to the On position for V.35 or
Off position for EIA-232.
Go to Powering Up the DSU , page 9.
Change the option card to set all six ports. Start with
the next section, Opening the DSU .
2
496-15149