BEFORE USING THE LIFT, IT IS NECESSARY TO CHECK THAT:
• The wheels turn and roll normally.
• The operation of the rear wheel brakes is correct.
• There is no wear or deformation on the hooks.
The device is delivered in 2 parts easy to assemble.
Step 1: Position the blue part facing the white base support as shown in the figure below:
At the end of the pre-positioning, the notch of the cylinder mounting bracket must be as shown :
Step 2: Position the clamping wheels, washers and threaded pin as shown in the figure and place
them in the 2 screw holes provided:
4
Manufactured by NAUSICAA Médical S.A.S. / Approved by Ghizlane Labrosse (Biomedical Engineer)
Installation Instructions
ASSEMBLY OF THE DEVICE
User manual / Stand up lift : BLUE WAYUP 3