Using Network Features - InFocus IN5148HD User Manual

Network
Allows you to configure the network settings for the Ethernet interface.
Status/Service:
RS232: allows you to select between 9600 and 19200 baud rates.
Source Info: a read-only display of current source settings.
Projector Info: a read-only display of current projector settings and lamp
hours.
Reset Lamp Hours...: resets the lamp hours used counter in the Projector Info
menu to zero. Do this only after changing the lamp.
Factory Reset...: restores all settings to their default.
Service Code...: only used by authorized service personnel.

Using Network Features

Manage the projector from a computer using a web browser when the computer
and the projector are properly connected to the same local area network.
Power Saving Mode must be turned Off in the Power menu for Ethernet control to
work when the projector is in standby.
Network Configuration
To configure the HDBASET network:
1
From the projector menu, navigate to Advanced Menu > Setup > Network.
2
DHCP is on by default. When connected to a network configured as a dynamic
host all the IP addresses should be automatically populated.
3
To set a fixed IP address, turn DHCP off, and navigate to the first IP address
you wish to modify.
4
Press Select and use the right and left arrows to navigate between the values
and the up and down arrows to change the selected value.
5
When done modifying the IP address, press Select and repeat the process for
other IP addresses as needed.
6
When done, select Apply, then Yes, and press Select.
31