Bosch 830 ES Installation And Operating Instructions Manual page 32

Installation instructions
Adjusting minimum power fan speed (P2)
To select fan speed:
▶ Push power button
▶ Push and hold the
P
▶ Turn power back on by pushing the power button
▶ Continue to hold the
screen light up and the temperature reads 188 °C.
▶ When display reads 188, immediately release the
button.
The display should now read P2.
▶ Press to enter P2 adjustment. The current setting will
P
appear on the display (factory default).
+
▶ Press or to choose the fan speed suitable with
your installation, see table 23 and 24.
▶ Press and hold (± 5 sec.) "Program" button
display flashes, then the selected value is memorized.
Proceed directly to chapter 7.4 to confirm CO
within range.
32
to shut the water heater off.
button.
button until all symbols on the
P
P
values are
2
Adjusting maximum power fan speed (P1)
To select fan speed:
▶ Push power button
▶ Push and hold the
.
▶ Turn power back on by pushing the power button
▶ Continue to hold the
screen light up and the temperature reads 188 °C.
P
▶ When display reads 188, immediately release the
button.
The display should now read P2.
▶ Press the minus button
▶ Press "Program" button
current setting will appear on the display.
+
▶ Press
until the
your installation, see table 23 and 24.
▶ Press and hold (± 5 sec.) "Program" button
display flashes, then the selected value is memorized.
Proceed directly to chapter 7.4 to confirm CO
within range.
to shut the water heater off.
button.
P
button until all symbols on the
P
to display P1.
to enter P1 adjustment. The
P
or to choose the fan speed suitable with
830 ES – 6 720 644 936 (2021/08)
.
P
until the
P
values are
2