Table of Contents
Advertisement
I Power
Connect the power cord to a wall outlet.
The demonstration appears in the display.
When you press "/1, the system turns on
and the demonstration automatically
ends.
If the supplied adaptor on the plug does
not fit your wall outlet, detach it from the
plug (only for models equipped with an
adaptor).
Inserting two R6 (size AA)
batteries into the remote
Slide and remove the battery
compartment lid, and insert the two
supplied R6 (size AA) batteries, E side
first, matching the polarities shown
below.
Note
If you do not use the remote for a long period of
time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
GB
18
Attaching the speaker pads
Attach the supplied speaker pads at each
corner on the bottom of the speakers to
stabilize the speakers and to prevent them
from slipping.
When carrying the unit
Perform the following procedure to
protect the disc mechanism.
Use the buttons on the unit for the
operation.
1
Press "/1 to turn on the system.
2
Press DVD.
3
Press OPEN/CLOSE Z to open
the disc tray and remove the
disc. If there are more than one
disc in the disc tray, press
DISC SKIP/EX-CHANGE to
remove the discs.
4
Press OPEN/CLOSE Z again to
close the disc tray. Wait until
"DVD No Disc" appears in the
display.
5
Hold down DVD and then press
"/1 until "STANDBY" appears
in the display. Then, "MECHA
LOCK" appears in the display.
6
Unplug the AC power cord.
Advertisement
Table of Contents
