Icom IC-7100 Instruction Manual page 13

4
Section
Section 1 PANEL DESCRIPTION
Section 2 INSTALLATION AND CONNECTIONS
Section 3 BASIC OPERATION
Section 4 D-STAR INTRODUCTION
Section 5 D-STAR OPERATION <BASIC>
Section 6 SET MODE
Section 7 INSTALLATION NOTES
D-STAR INTRODUCTION
"MY" (Your own call sign) programming .............................4-2
D-STAR Introduction .............................................................4-5
About the DR (D-STAR Repeater) mode ..............................4-5
Communication Form in the DR mode ................................4-6
IMPORTANT!
• The repeater list described in this manual may differ from your trans-
ceiver's preloaded contents.
• Although Japanese repeaters are used in the setting examples, the
Japanese repeater node (port) letters are different from those in other
countries.
Be sure to add a repeater node letter as the 8th digit in the call sign
field after a repeater call sign according to the repeater frequency band
shown below.
1200 MHz: A (B in Japan)
430 MHz:
144 MHz:
"AI" means "Advanced Instructions."
"sec. MM" means section number.
So when "(AI sec. MM)" is described on this manual, see the PDF type
Advanced Instruction's section number for your reference.
B (A in Japan)
C (no D-STAR repeaters in Japan)
4-1