Table of Contents
Advertisement
4 Interfaces
4.1.2
RS-232
The RS-232 interface is normally used as additional console device for Linux. It can also be configured for
use by a custom application.
The TX and RX signals use the power supply GND pin 1 as reference potential. Make sure that the remote
device uses the same GND reference.
Default settings for the serial interface:
4.1.3
USB
A USB device can be connected to pins 13 (D+) and 14 (D-). The interfaces supports High-Speed signal rate
of 480 Mbit/s. Pin 17 provides +5 V power supply to the device (max. 900 mA).
USB recovery mode:
Connecting pin 16 to GND during power-on will put the device into USB recovery mode. This is indicated
by a green blinking power LED. Only use this mode if advised by IMAGO. Do not try to flash the Jetson OS
image provided by NVIDIA!
Setting
Value
Baud rate
115200 bps
Parity
None
Data bits
8
Stop bits
1
Flow control
None
IMAGO Technologies GmbH
info@imago-technologies.com;
www.imago-technologies.com
Page 13 / 24
Advertisement
Table of Contents
