Behringer SYSTEM 100 172 PHASE SHIFTER/DELAY/LFO Quick Start Manual page 5

8
SYSTEM 100 172 PHASE SHIFTER/DELAY/LFO
SYSTEM 100 172 PHASE SHIFTER/DELAY/LFO Controls
(3)
(1)
(2)
(8)
(9)
(10)
(11)
(4) (5) (6)
(7)
(12)
(13)
(14)
(1) CV IN – Accepts voltage from an external source to control or
Controls
(EN)
modulate the phase shifter frequency or audio delay time. If no
jack is inserted the LFO can be used to modulate the effect.
(2) MOD INTENSITY – Controls how much the effect is modulated by
the LFO or external CV input.
(3) EFFECT ON/OFF – Engages or disengages the effect section.
(4) SHIFT FREQ – Adjusts the frequency of the phase shifter.
(5) SIG IN – Accepts an incoming signal via 3.5 mm TS cable.
(6) SIG OUT – Sends the signal from the effect section.
(7) RESONANCE – Adjusts the amount of signal that is fed back
through the effect.
(8) DELAY TIME – Adjusts the time of the delay effect.
(9) FREQUENCY – Controls the LFO output frequency.
LFO OUT – Sends the LFO signal as a triangle and inverted
(10)
triangle wave.
THRESHOLD – Controls the input voltage level required to trigger
(11)
the gate.
GATE IN – Accepts an incoming gate signal via 3.5 mm TS cable.
(12)
GATE OUT – Send the gate delay signal via 3.5 mm TS cable.
(13)
GATE TIME – Controls the gate length.
(14)
9
Quick Start Guide