Sony CDP-CX100 Operating Instructions Manual page 36

Hide thumbs Also See for CDP-CX100:
Table of Contents

Advertisement

Bi celere)i=s-atexeyeiare
Before going through the check list below, first refer back to the applicable connections and operating
procedures. Should problem persist after you have checked these items, consult your nearest Sony
service facility.
Symptom
Play does not start.
"-NO DIsc~"i is saplajed
Play begins only by tuning 0
on ue 'Power,
No sound is heard.
Play does not begin from the first
selection.
Two or more discs cannot be slaved
consecutively.
"+ "1 is displayed.
The remote commander does not operate
the player.
The JOG dial on the remote commander
does not operate.
The 6 rary table does not rotate.
The player's functions operate incorrectly.
Sony Corporation
Printed in Japan
Cause
Remedy
Clean the disc.
Insert the disc with the label facing tight.
The disc is dirty.
The disc is inserted with the label iecing left.
The player is in pause mode.
Kciaiure has condensed.
Press > or If to release pause.
caave the 'ayer on for approximately
one hour.
Insert the disc with the labe! siacing right.
Select a used disc slit.
Pa! the TIMER switch to OFF,
The disc is inserted with the label facing left.
Empty disc slit is ores
The TIMER switch is set to PLAY.
There is a loose connection.
Insert the plug firmly.
Check the connection referring to
"Hooking up the system".
Turn the control clockwise.
The connection is incorrect.
The LINE OUT/ PHONE LEVEL contro! is
set to the minimum.
The player is in program or shuffle ied
Press CONTINUE.
mode.
The player is in the 1 DISC mode.
Press CONTINUE to choose ALL
DISCS mode.
>> was continuously pressed at the end
Press <4 or 144 to return to the normal
of the disc.
indication.
The batteries are run down.
Replace both batteries.
Point the remote commander at the
sensor.
Remove the obstacle.
The remote commander is not 'tinied at
the remote sensor.
There is an obstacle between the remote
commander and the player.
The remote commander is too far from the
Move it closer.
player.
The CD 1-2-3 selector on the remote
Synchronize the selectors.
commander is not synchronized with the
atest NODES selector on the rear naga
Press JOG ON/OFF to turn on the
indicator.
The JOG ON/OFF button is not pressed.
Press UNLOAD to turn on the indicator.
A disc is set to the playing position.
Press GROUP 1-10 to cancel group play.
The player is in group play mode.
Turn the power off, then turn it back on
to reset ie player.
The microcomputer chips may be operating
incorrectly.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdp-cx100s

Table of Contents